Description
Update your lighting with ivory vertical dual-switch new GE low volt light plate in a single-gang configuration. This one-gang two-opening low voltage face plate holds a pair of GE new clip-in electrical light switches without using brackets, yokes, or straps. These are visually similar to the 2-Switch Bracket Mount Wall Plates. Devices are held in place by the wallplate itself saving you the additional cost of a bracket.
Features
- ivory enamel finish; .030" steel
- USA-made replacement low volt switch plates
- custom made; Kyle Switch Plates exclusive cover
- NO bracket or mounting strap required - switches snap into cover from front
- standard 2-3/4" W x 4-1/2" H x 5/32" D single gang cover
- clip-in opening is 1-9/32" H x 49/64" W
- 2 ivory 1/2" installation screws
If you install this plate vertically (screws above and below), then the upper button on each switch will turn on lights; the lower button will turn them off.
If cover plates are horizontally installed (screws left and right) then the left button turns fixtures on and the right button turns them off.
