Description
Create deep screwless wall plates for protruding wall boxes with gap filler wall plate depth extender rings for Legrand Radiant light switchplates. Stack these 1/8" thick spacers under a screw-less Legrand Radiant Collection wall plate to cover up a 1/4", 3/8" 1/2" or deeper gap around a wall box that is sticking out from the wall. This situation occurs with standard boxes on shallow outer walls, rooms where wood paneling was removed, or electrical devices that don't fit completely into shallow boxes because of bulky wiring that requires a fire safety box extender. Fits around a single gang box fitted with a Radiant light switch, GFCI outlet, light dimmer, etc.
Features
- 4.87" high x 3.07" wide x 1/8" thick (4-7/8" x 3-1/16")
- stack multiple rings to create deeper depths - .25", .375", .5", .62", etc.
- inner opening 4.25" H x 2.31" W (4-1/4" x 2-5/16")
- adds border under single-gang Radiant collection trim plate to fill gap
- fits around most electrical boxes - measure your box to ensure there is enough clearance
- held in place by friction when plate is installed over it
- Kyle Switch Plates exclusive item
- gloss acrylic, clean with warm water
- use a goof ring and screw spacers for mounting devices protruding from box
- for use on flat surfaces only; sand wall surface to remove bumps
- do not bend or item may crack
- white hard plastic gaskets
- designed for use with 1-gang Radiant hidden-screw wallplates
- Radiant is a Pass & Seymour Legrand trademark
- WARNING: for indoor decorative use only. Ensure devices are properly installed in box. Important: if using with protruding devices, must use fire safety box extenders and spacers to ensure devices are safely installed
- American made
Uses
- Hide sides of standard electrical box in shallow wall
- Add an edge behind wall plate to hide bulky devices