Description
Hide gaps under our extra deep wall plate covers with this rounded-corner depth ring wall plate extender. Stack these 1/8" extension rings to cover up undesirable gaps around an old junction box that sticks out because of removed paneling. Also use these decorative gap fillers on exterior cement walls where you can't install a deeper box or to make room for new deeper dimmers, timers or other bulky electrical devices when used with fire safety box extenders.
Works with our single gang standard size switchplates (4.5" x 2.75") with and most electrical devices including rocker or toggle light switches, dimmers, GFCI electrical outlets, duplex receptacles.
Designed to closely align with the edges of our extra deep metal wall plates in four sizes: extra deep duplex outlet plates, extra deep toggle plates, extra deep blank plates, and extra deep 1.4" outlet covers.
Features
- 4.5" H x 2.75" W x approximately 1/8" D (3mm), stackable to needed depth
- designed for fit our extra deep plates with rounded corners that are 4.5" H x 2.75" W
- hard plastic rings in white
- for use on flat surfaces only; sand wall to remove bumps
- do not bend or item may crack
- inner opening 4.25" H x 2.25" W
- stack the spacer rings to create the depth you need - .25", .375", .5", .62", etc.
- provides a cosmetic fix when mounting switch plates
- held in place by friction of tightening your plate onto it, or by using electrical tape or caulking
- purchase cover plate separately if needed
- made exclusively by Kyle Switch Plates
- gloss acrylic, clean with warm water
- fits around most electrical boxes - measure your box to ensure there is enough clearance
- mounts externally - creates an 1/8" raised edge under your trim plate
- does not fit midsized, tall, or oversized covers
- if using with plates purchased elsewhere, measure your plates to ensure a good fit
- custom item made in USA
- WARNING: for decorative use only. Ensure devices are properly installed in box. Important: if using with protruding devices, must use fire safety box extenders and spacers to ensure devices are safely installed
Uses
- Hide edges of electrical box that protrudes from wall
- Build up area around electrical box if bulky wiring causes devices to stick out of box when used with fire safety box extenders
