Description
Update a midcentury 9-switch Remcon low voltage dial control panel with Touchplate's Classic eighteen-button control unit. These units are designed with nine pairs of buttons that correspond to the rocking, flared switches on the vintage central control panels. The button pairs are arranged left ON/right OFF as compared to the switches on the old Remcon units where the top button/up direction was ON, the lower button/down direction was OFF. Available for special order in white, almond, or ivory for a stylish solution to refresh your existing low voltage set-up. Each switch station has nine pairs of 1/2" square button caps.
Features
- replace a unit with nine Remcon low voltage switches with this 18-button (9-pair) control unit
- 8 pairs of buttons each replace one Remcon switch; the last pair could be used for a new device
- left buttons are the ON switches, right buttons are the OFF switches in each pair; each gang is stacked three pairs high across three gangs
- installs on a three-gang box or mounting ring; vintage Remcon units were installed on a 4-gang box - see installation notes below
- 2 wire switches easily adapt to a 3-wire system by doubling the number of buttons creating pairs of ON/OFF buttons
- note: all 9 relays connected to these switch controls must be the same brand
- note: pilot light functionality (little lights inside the buttons to indicate if a load was on) is no longer be available
- 1 amp @ 28 volts switch contact rating
- 18 momentary contact switches; dry contact
- free 3-wire to 2-wire low voltage installation guide to make adapting them easy
- 6.5" x 4.75" metal switchplate frame and cover
- plate has three 2" x 1-9/16" switch cutouts to fit around the face of three 6-button sets
- 3-9/32" screw hole spacing in metal bracket
- back depth is 5/8"; overall depth is 15/16" from front of button to back of terminal bar
- six 1.5" mounting screws for installing yoke to box, screw plate presses onto yoke
- made in America
SPECIAL ORDER: WHITE IS STOCK; ALMOND AND IVORY HAVE A 2-3 BUILD TIME
Click Low Voltage Lighting Replacement Controls and Switches for relays and more switch options.
REMCON UPGRADE INSTALLATION NOTES: If you are changing out parts on a Remcon low voltage system and your current master panel has either lighted or unlighted switches, then this is the correct replacement. LED lighted switches require a 4th wire for illuminating them which may not be available on Remcon systems. Note that this panel fits a 3-gang box, but the 9-button master panel was installed on a 4-gang box. If there is no box in the wall, the 3-gang low voltage ring and the 3-gang 8" x 6" extender panel may allow you to cover the gap and avoid having to patch drywall. Note that the master switch would no longer work as that specific functionality was unique to Remcon hardware. Only the original 8 light switches would work with the eight pairs (ON/OFF) of new buttons.
