Description
Half Short 2 Rocker Decor GFCI Wall Plate - Light Almond
These trimmed 2-gang rocker wall plates are 3/16" shorter on one side (top or bottom - rotate as needed) than standard switch plates. They are made with smoothly beveled edges on all sides. The perfect solution for spacing problems above or below your electrical box.
Uses
- cover 2 electrical boxes that are too close together
- wall box positioned right next to bottom of a cabinet or over a countertop
- wall tile installed too close to the electric box
Features
- Kyle Switch Plates custom design
- light almond metal cover for 2-gang box
- 4-9/16" W x 4-1/2" H x 5/32" D
- one trimmed side (top or bottom)
- professionally finished beveled edges on all sides
- Decora rocker switch opening is 3/4" from edge of wallplate on one end; 1-1/8" from the other edge
- .5" installation screws included
- device openings are for rocker, GFCI, and Decora devices (Decora is a Leviton trademark term)
- standard Decora opening: 1 5/16" W x 2 5/8" H
- made in USA
Installation: These custom switch plates have screw holes drilled 3.281" apart (box mount) instead of strap mount (typically 3.812" for rocker covers) because of the edge trim. When installing, use the same screw through both the plate and device into the wall box. Light almond mounting screws are included.
Will it fit? Measure from the middle of the screw that holds the device in the box to the edge of nearest obstruction (trim, cabinet, backsplash, etc.). If it is at least 11/32" (or 8.7mm), the switchplate will fit.