Description
Swap out your older 12-pilot light GE low voltage dial control wall station with this Touchplate 24-button LED control unit for a fresh new look. These units are designed with twelve pairs of buttons that correspond to the two dial directions on the vintage GE RMS-4A, as well as the very old rocking mini switches or the more-recently discontinued double square pushbutton switches where one button/one direction was ON, the other button/direction was OFF. Note that if replacing the 12-switch dial controller it will requiring replacing the 2-gang box with a 4-gang box. Choose from white, almond or ivory for a stylish solution to refresh your existing low voltage set-up. Each switch station has twelve pairs of 1/2" square button caps. NOTE: the buttons are NOT engraved - the faint ON/OFF words in the image are just for reference.
Features
- this modified 24-button unit is an alternative solution to replace a control station with twelve GE low voltage pilot light switches on a 4-gang box
- can be installed vertically or horizontally per the direction of your wall box - if installed vertically pairs are left/right; if installed horizontally pairs are top/bottom
- replaces twelve RS237P, RS232P, RS239P, RTS-8, RFS-8, RCS2PL, etc. switches in GE, Bryant, and Sierra systems
- note: RR9 pilot light relays are required to power the LED lights; please be sure you have the extra wiring and the RR9 pilot light relays installed
- note: all 12 relays connected to switch must be the same brand
- 2 wire switches easily adapted to a 3-wire system by doubling the number of buttons with pairs of ON/OFF buttons - one button in a pair is ON, the other button in a pair is OFF
- pilot lights with 12 green LED bulbs that light up when the connected fixtures are ON. (Other 12 LED's on lower/OFF buttons will never light up.)
- 1 amp @ 28 volts switch contact rating - designed with reverse polarity for use with GE/Bryant/Sierra systems
- 24 momentary contact switches (12 pairs) modified with reverse polarity for use with GE systems; dry contact
- easy wiring installation with the free 3 wire to 2 wire low voltage conversion guide included
- 8.375" x 4.75" metal switchplate
- four 2" x 1-9/16" switch opening holes
- 3-9/32" screw hole spacing
- eight 1-1/2" white installation screws
- back depth is 5/8"; overall depth is 15/16" from front of button to back of terminal bar
- American made
- white is stock - almond or ivory controls are special order
Click Low Voltage Lighting System Replacement Devices for relays, transverter power supplies, and more switch options.
