Description
Update your vintage 2-pilot lighted GE low voltage light plate unit with these Touchplate four-button control units for a fresh new look. These units are designed with dual pairs of buttons that correspond to the two directions on the vintage GE teeter-totter switches or the more-recently discontinued double square pushbutton switches where one button/one direction was ON, the other button/direction was OFF. Choose from white or ivory for a stylish solution to refresh your existing low voltage set-up. Each switch station has two pairs of 1/2" square button caps.
WHITE IS STOCK; OTHER COLORS ARE SPECIAL ORDER WITH A 3-WEEK LEAD TIME
Features
- this 4-button unit is an alternative solution to replace a control station with two GE low voltage pilot light switches
- replaces two RS237P, RS232P, RS239P, RTS-8, RFS-8, RCS2PL, etc. switches in GE, Bryant, Remcon and Sierra systems
- 2 wire switches easily adapted to a 3-wire system by doubling the number of buttons with pairs of ON/OFF buttons
- pilot lights with 2 green LED bulbs that light up when the connected fixtures are ON. (Other two LED's on lower/OFF switch will never light up.)
- note: RR9 pilot light relays are required to power the LED lights; please be sure you have the extra wiring and the RR9 pilot light relays installed
- note: both relays connected to switch station must be the same brand
- 1 amp @ 28 volts switch contact rating
- 4 momentary contact switches; dry contact
- free 3 wire to 2 wire low voltage conversion guide to make installation easy
- 4-1/2" x 2-3/4" plastic screw-less light switch cover
- 2" x 1-9/16" switch cutouts
- 3-9/32" screw hole spacing center to center in metal yoke
- back depth is 5/8"; overall depth is 15/16" from front of button to back of terminal bar
- two 1" mounting screws
- made in America
- cannot be used side by side in a 2-gang box: instead order a GE Low Voltage 4-Pilot Light Switch Unit ON/OFF Pairs - 2-Gang to replace 4 GE LED switches on a 2-gang box.
Click Low Voltage Replacement Devices for relays, transverter power supplies, and more switch options.
Q & A
Q. Can this unit replace two low voltage 3-way switches with pilot lights?
A. Yes, it can. In momentary systems they are not really "low voltage 3-way switches" but instead are wired in parallel to the relay they are controlling to achieve the same outcome. When wired in parallel an unlimited number of switches can be controlling the same light. The relay just responds when receiving a signal from any of the switches to which it is hooked up. (Note that the only the ON LED light will illuminate when the load is running. The LED light on the OFF buttons will be disabled. )
Q. My box is installed vertically in the wall. Can I install this unit?
A. Yes, this unit works whether it is oriented vertically or horizontally.