Description
Swap out an older 6-switch GE low voltage light station with this classic lighting control unit for a fresh new look. These stations are designed with six pairs of buttons that correspond to the two directions on the vintage GE rocking teeter-totter switches or the more-recently discontinued double square pushbutton switches where one button/one direction was ON, the other button/direction was OFF. Stack two of these control stations on the wall to replace the GE 12-switch dial-control units by adding another 2-gang box above or below your current 2-gang box (or to the side if space allows). Choose from white, almond or ivory for a stylish solution to refresh your existing low voltage set-up. Each switch station has six pairs of 1/2" square button caps. NOTE: the buttons are NOT engraved - the faint ON/OFF words in the image are just for reference.
Features
- modern-looking, compatible solution for replacing midcentury GE low voltage switches that are now all discontinued
- this 12-button unit is an alternative option to replace a control station with six GE low voltage unlighted switches on a double-gang box
- if replacing a pilot light version with this new unlighted version: the RR9 pilot light relays connected to the old pilot lighted switches can be used with these new switches; simply cap off the wires used for illuminating the pilot lights
- can be installed vertically or horizontally per the direction of your wall box - if installed vertically pairs are left/right; if installed horizontally pairs are top/bottom
- use two of these units mounted in a pair of 2-gang boxes to replace one 2-gang 12-switch GE dialing control station RMS-4A
- note: all six relays connected to switch must be the same brand
- replaces six RS237, RS232, RS239, RTS-6, RFS-6, RCS2, etc., switches in GE, Bryant, and Sierra systems
- 2 wire switches easily adapted to a 3-wire system by doubling the number of buttons to create ON/OFF buttons pairs - one button in a pair is ON, the other button is OFF
- 1 amp @ 28 volts switch contact rating
- 12 momentary contact switches (6 pairs); dry contact
- easy to install with the free 3 wire to 2 wire low voltage conversion guide included
- 4-1/2" x 4-1/2" plastic screw-less press-on wallplate
- two 2" x 1-9/16" switch cutouts
- 3-9/32" screw hole spacing center to center in metal yoke for installing to standard wall box (see 2-gang low voltage mounting ring if no box is used)
- back depth is 5/8"; overall depth is 15/16" from front of button to back of terminal bar
- engraved ON and OFF button caps can be purchased separately if needed; caps fit buttons whether plate is installed vertically or horizontally
- four 1" installation screws
- made in USA
Click Vintage Smart Home Low Voltage Lighting System Replacement Devices for relays, transformers, power supplies, plates and more light switch options.
