Description
Hide exposed wall box with gap filler wall plate depth extender ring for Lutron screwless light switch covers. Stack these 1/8" thick spacers under a Lutron Claro wall plate to cover up a 1/4", 3/8" 1/2" or deeper wall box that is sticking out from the wall. This situation occurs with standard boxes on shallow walls, updated walls where paneling was removed, or when electrical switches don't fit fully into shallow boxes (when used with fire safety box extenders). Fits around a single gang box fitted with a Lutron decorator light switch, outlet, dimmer, etc.
Features
- 4.68" high x 2.93" wide x 1/8" thick (4-11/16" x 2-15/16")
- stack multiple units to create extra depths - .25", .375", .5", .62", etc.
- inner opening 4.25" H x 2.31" W (4-1/4" x 2-5/16")
- adds border under single-gang Lutron screw-less wallplate to fill gap
- fits around most electrical boxes - measure your box to ensure there is enough clearance
- held in place by friction when plate is installed over it
- Kyle Switch Plates exclusive item
- designed for use with 1-gang Lutron wall plates
- Lutron is a trademark of Lutron Electronics
- gloss acrylic, clean with warm water
- use a goof ring and screw spacers for mounting devices protruding from box
- for use on flat surfaces only; sand wall to remove bumps
- do not bend or item may crack
- white, ivory, gray or black hard plastic gaskets
- WARNING: for indoor decorative use only. Ensure devices are properly installed in box. Important: if using with protruding devices, must use fire safety box extenders and spacers to ensure devices are safely installed
- American made
Uses
- Hide sides of standard electrical box in shallow wall
- Add an edge behind wall plate to hide box extender used with bulky devices
